Board ID: XEPI-232 (16/PLUS)(RMT)
Version: 1.2.3
Serial: FD9A19130000
Probe Voltage: 12772mV
Last Response: 053 Connection Failure: "Failed to open PPP connection" [Start PPP]
Connection Details:
001 Initializing Interface: [Connect Modem]
 Waiting Network
Initialize Modem
MSG:Press ESC to enter Config Mode...
MSG:ETM9800 SYSTEM START SW#:SW981N051R02 20080821 CT0204
MSG:Searching for device..........
MSG:Device detected on port 0
MSG:HC25/28(MdmNet) serial device detected
MSG:SERIAL DEVICE READY
Matched 'MSG:SERIAL DEVICE READY'
AT&D2
OK
Matched 'OK'
AT&C1
OK
Matched 'OK'
AT^SLED=1
OK
Matched 'OK'
AT+CSQ
+CSQ: 5,99
OK
Matched 'OK'
Connect
ATS0=0
OK
Matched 'OK'
ATD*99***1#
CONNECT
Matched 'CONNECT*'
Connected
001 Initializing Interface: [Connect Init]
 Initialise TCP/IP Stack
001 Initializing Interface: [Start PPP]
 Connecting
053 Connection Failure: 
 Failed to open PPP connection
Disconnect
NO CARRIER
Matched 'NO CARRIER'
ATH
OK
Matched 'OK'
AT^SMSO
OK
Matched 'OK'
Telemetry Initialize
MSG:Press ESC to enter Config Mode...
MSG:ETM9800 SYSTEM START SW#:SW981N051R02 20080821 CT0204
MSG:Searching for device..........
MSG:Device detected on port 0
MSG:HC25/28(MdmNet) serial device detected
MSG:SERIAL DEVICE READY
Matched 'MSG:SERIAL DEVICE READY'
AT&D2
OK
Matched 'OK'
AT&C1
OK
Matched 'OK'
AT^SLED=1
OK
Matched 'OK'
AT+CSQ
+CSQ: 4,99
OK
Matched 'OK'
Telemetry Enable
ATS0=1
OK
Matched 'OK'
Telemetry Disable
ATH
OK
Matched 'OK'
ATS0=0
OK
Matched 'OK'
AT^SMSO
OK
Matched 'OK'
001 Initializing Interface
001 Initializing Interface: [Idle]
 Process URL